Ethical hacking tutorials

Creating A Permanent Paging File In Windows XP

Like in Windows 2000, it takes a little digging in Windows XP to get where you want.

First, open up System Properties, either through the Control Panel or by right-clicking on the My Computer icon and selecting Properties.

Once in System Properties, click on the Advanced tab. There will be three sections.

Click on Settings in the Performance section and the Performance Options screen will pop up. Click on the Advanced tab and you'll see the following picture :-

The second section you see is titled Virtual memory. Under it, there's a Change button. Click on it to get the following screen :-

You can select the logical drive you wish to place the paging file in by clicking on the list of logical drives shown on the screen. Again, the selection of logical drives will be discussed in detail later in this article.

To create a permanent paging file, both values for the Initial size and the Maximum size must be the same.

Please note that Windows XP will dynamically expand the paging file when you run out of memory, even if you create a permanent paging file. When this happens, you will get an error message telling you that Windows XP is trying to expand the paging file to create more virtual memory.

In this example, we are using an arbitrary value of 512MB. Once you set the two values, click on OK and then let Windows XP reboot the system. A permanent paging file will be created on your hard disk.

You will note that Windows XP does not allow a paging file size of less than 2MB.